Xpress Retail

Wireless Doorbells

1. Put a flat screwdriver into the slots on the back of the button to take the back off.

2. Insert the 12V battery (included).

3. Close it again and then stick it where you would like using the adhesive back.

4. Insert the 2 * AAA batteries (not included) into the receiver by opening the battery panel.

5. Use the button on the side of the receiver to cycle through the different melodies to find your favourite. 

6. Use a screw or hook to hang the receiver where you would like. Alternatively, you could place it on a table or shelf. 

Technical Issues Help

Only Working When Button and Receiver are Near Each Other

1. Remove the back cover from the button.
2. Near the battery you will see a small screw (flathead screwdriver required).
3. Move away from the main unit to a distance that doesn't currently work.
4. Turn the screw very slowly in each direction from the starting position while holding the button down (the battery must also be in the unit).
5. When the main unit is set off and starts ringing, start again from step 3 and continue until this works at the required distance.